2020-02-05

Back Panel – 2nd Row Seat – RH (Remove and Replace)

Correction code 13082312 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Move the front passenger seat fully forward, and then open the RH rear door and lower the RH rear window.
  2. Fold down the rear RH/40 seat.
  3. Use a trim tool to release the clips that attach the back panel to the seat, working from the top of the seat towards the bottom.
  4. Maneuver the back panel towards the front of the vehicle to release the guiding tabs from the seat.
  5. Remove the back panel from the vehicle.

Install

  1. Insert the guiding tabs on the back panel into the slots on the seatback assembly.
  2. Starting from the bottom and working your way up, install the back panel by pressing on the back panel to engage all clips into the seatback assembly.
  3. Raise the RH/40 seat.
  4. Raise the window, move the front passenger seat to its starting position, and then close all doors.