02/11/2023 01:08:29

Fascia - Rear - Upper (Remove and Replace)

Correction code 10012802 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

2023-11-02: Added notes to distinguish between the steps for HW3/HW4 vehicles.

Torque Specifications

Table 1. Torque Specifications: Fascia - Rear - Upper (Remove and Replace)
Description	Torque Value	Recommended Tools	Reuse/Replace	Notes
Bolts (x6) that attach the lower rear fascia to the upper rear fascia	3 Nm (2.2 lbs-ft)	10 mm socket 4 in extension	Reuse

Remove

Remove the rear fascia. See Fascia - Rear (Remove and Install).
For HW3 vehicles, release the connector locks (x2), and then disconnect the rear fascia harness connectors (x6).

Note
Skip this step for HW4 vehicles.

Note
Do not push down on the red locking tab. Pull the red tab to release the connector lock.
For HW3 vehicles, remove the clips that attach the rear fascia harness to the upper rear fascia, and then remove the harness from the assembly.

Note
Skip this step for HW4 vehicles.
Remove the bolts (x6) that attach the lower rear fascia to the upper rear fascia.
3 Nm (2.2 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
Remove the metal clips from the center of lower rear fascia.
Release the tabs (x17) that attach the upper rear fascia to the lower rear fascia, and then separate the upper rear fascia from the lower rear fascia.
Remove the rear parking distance sensors from the upper rear fascia for HW3 vehicles. See Sensor - Parking Distance - Inner - Rear (Remove and Replace).

Note
Skip this step for HW4 vehicles.