04/09/2024 15:18:30

Skid Plate - HV Battery - Rear (Remove and Replace)

Correction code 16102202 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-05-25: Added the whole procedure video as an overview for supplemental purposes only.

Torque Specifications

Table 1. Torque Specifications: Skid Plate - HV Battery - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the rear skid plate to the lower HV battery
13 Nm (9.6 lbs-ft)
  • External Torx Plus EP10
  • 4 in extension
  • Ratchet/torque wrench
Reuse
Nut that attaches the rear skid plate to the upper HV battery
13 Nm (9.6 lbs-ft)
  • 10 mm socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse
Bolts that attach the rear skid plate to the upper HV battery
30 Nm (22.1 lbs-ft)
  • 13 mm socket
  • 3 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the mid aero shield. See Panel - Aero Shield - Mid (Remove and Replace).
  2. Release the clips (x2) that attach the coolant hose to the LH shear plate.
  3. Release the clips that attach the hoses to the rear HV battery skid plate
  4. Remove the lower bolts that attach the skid plate to the HV battery.
    13 Nm (9.6 lbs-ft)
  5. Remove the upper nut that attaches the skid plate to the HV battery.
    13 Nm (9.6 lbs-ft)
  6. Remove the upper bolts that attach the skid plate to the HV battery, and then remove the skid plate from the HV battery.
    30 Nm (22.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles are equipped with self-tapping bolts from the factory. If the vehicle is equipped with a bolt with a hexagonal indentation on the bolt head (1637725-00-A), the torque value is 64 Nm.

Install

Installation procedure is the reverse of removal.