2021-10-11

Cover - Shock Tower - LH (Remove and Replace)

Correction code 12251012 0.06NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Cover - Shock Tower - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the underhood storage unit to the washer fluid reservoir neck
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Open the LH front door and fully lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the bolt that attaches the underhood storage unit to the washer fluid reservoir neck.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
  4. Release the tabs that attach the washer hose to the washer tank neck, and then remove the washer tank neck from the vehicle.
  5. Release the clip that attaches the harness to the LH shock tower cover.
  6. Release the clips that attach the LH shock tower cover to the vehicle, and then remove the cover from the vehicle.

    LH shock tower cover shown, RH similar

Install

Installation procedure is the reverse of removal.