26/03/2020 08:55:16

Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace)

Correction code 12030102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Aero shield panel to body nuts
5.5 Nm (4.1 lbs-ft)
  • 15 mm socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 4 in extension
Reuse
Aero shield panel to body bolts
5.5 Nm (4.1 lbs-ft)
  • 10 mm socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 4 in extension
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the bolts (x7) that attach the front aero shield panel to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension
  3. Remove the nuts (x2) that attach the front aero shield panel to the vehicle, and then remove the panel from the vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension

Install

  1. Apply a thin bead of Loctite 222 to the threads of the bolts (x7) that attach the front aero shield panel to the vehicle.
  2. Install the front aero shield panel to the underside of the vehicle, and then hand-tighten the nuts (x2) to temporarily hold the panel in place.
  3. Hand-tighten the bolts (x7) that attach the front aero shield panel to the vehicle.
  4. Torque the nuts (x2) and bolts (x7) to the proper specification.
    5.5 Nm (4.1 lbs-ft)
    5.5 Nm (4.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket and 10 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension
  5. Lower the vehicle. See Raise Vehicle - 2 Post Lift.