Handle - Exterior Release - Door - Front - LH (Remove and Replace)
Correction code
11451002
0.72
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Nuts that attach the LH front door exterior release handle to the door |
 7 Nm (5.2 lbs-ft) |
|
Reuse |
Remove
- Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
- Remove the LH front door inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
- Remove the front LH door glass. See Glass - Door - LH - Front (Remove and Replace).
- Remove the LH front door closeout panel. See Closeout Panel - Door - Front - LH (Remove and Install).
-
Disconnect the electrical wiring harness from the door handle connector.
-
Remove the plugs that cover access to the door handle nuts.
-
Remove the nuts that attach
the door handle to the door, and then remove the handle from the door.7 Nm (5.2 lbs-ft)Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- ¼ in std ratchet
- ¼ in torque wrench (installation only)
- 6 in extension
Install
Installation procedure is the reverse of removal, except for the following:
- When a new handle is installed, or the removed handle is installed onto a new door, perform an adjustment of the handle. See Handle - Exterior Release - Door - Front - LH (Adjust).