14/05/2021 08:59:55

Harness - 2nd Row Seat - RH (Remove and Replace)

Correction code 17100082 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all the doors and fully lower all the windows.
  2. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Disconnect the RH 2nd row seat frame electrical connector.
  4. Remove the RH 2nd row seat back shoulder switch. See Shoulder Switch – Seat Back – 2nd Row – LH (Remove and Replace).
  5. Remove the RH 2nd row back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).
  6. Disconnect the RH 2nd row seat heater electrical connector.
  7. Release the RH 2nd row seat heater connector clip.
  8. Release the shoulder switch harness from the RH seat upholstery support.
  9. Disconnect the RH 2nd row seat recline harness.
  10. Release the clips (x3) that attach the harness to the lower RH 2nd row seat.
  11. Remove the RH 2nd row seat harness from the harness guides, and then remove the harness from the vehicle.

Install

  1. Install the RH 2nd row seat harness into the harness guides.
  2. Install the clips (x3) that attach the harness to the lower RH 2nd row seat.
  3. Connect the RH 2nd row seat recline harness.
  4. Install the shoulder switch harness into the RH seat upholstery support.
  5. Fasten the RH 2nd row seat heater connector clip.
  6. Connect the RH 2nd row seat heater electrical connector.
  7. Install the RH 2nd row back panel. See Back Panel – 2nd Row Seat – RH (Remove and Replace).
  8. Install the RH 2nd row seat back shoulder switch. See Shoulder Switch – Seat Back – 2nd Row – LH (Remove and Replace).
  9. Connect the RH 2nd row seat frame electrical connector.
  10. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  11. Raise all the windows and close all the doors.