2021-05-20

Duct - Air Wave - LH (Remove and Replace)

Correction code 18108002 1.98 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the IP carrier. See IP Carrier (Remove and Replace).
  2. Remove the screws (x2) that attach the LH air wave duct to the cross bar beam, and then remove the duct from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket
    • Flex head ratchet / flex head torque wrench
    • 4 in extension

Install

  1. Install the LH air wave duct to the cross car beam, and then install the screws (x2) that attach the duct to the beam.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket
    • Flex head ratchet / flex head torque wrench
    • 4 in extension
  2. Install the IP carrier. See IP Carrier (Remove and Replace).