04/09/2024 13:57:33

Ground Strap - Rear Drive Unit (Remove and Replace)

Correction code 40012202 1.74 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-01-12: Updated torque figure for the bolt that attaches the ground strap to the RDU from 6 Nm to 10 Nm.
  • 2023-06-15: Added the whole procedure video as an overview for supplemental purposes only.

Remove

  1. Remove the rear subframe assembly from the vehicle. See Subframe Assembly - Rear (Remove and Install).
  2. Release the clip that attaches the rear drive unit ground strap to the subframe.
  3. Remove the bolt that attaches the rear drive unit ground strap to the rear drive unit assembly.
    Tip: Use of the following tool(s) is recommended:
    • 10mm socket
    • 4 in extension

Install

  1. Install the bolt that attaches the rear drive unit ground strap to the rear drive unit assembly.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10mm socket
    • 4 in extension
  2. Install the clip that attaches the rear drive unit ground strap to the subframe.
  3. Install the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).