2024-05-16

Assembly - Trailer Hitch (Remove and Replace)

Correction code 12300202 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-05-16: Added instructions to prevent corrosion on EU trailer sockets.

Torque Specifications

Table 1. Torque Specifications: Assembly - Trailer Hitch (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Trailer hitch assembly to body studs
62.5 Nm (46.1 lbs-ft)
  • 15 mm, 6-point deep socket
  • 6 in extension
 Reuse

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Disconnect the trailer hitch assembly electrical connector.
  3. Remove the LH nuts (x3) and RH nuts (x3) that attach the trailer hitch assembly to the studs on the body of the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm, 6-point deep socket
    • 6 in extension
  4. Remove the trailer hitch assembly from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Recommend assistance when performing this step.

Install

  1. Maneuver the trailer hitch assembly in place so that the holes are placed over the studs on the body of the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Recommend assistance when performing this step.
  2. Install the LH nuts (x3) and RH nuts (x3) that attach the trailer hitch assembly to the studs on the body of the vehicle.
    62.5 Nm (46.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm, 6-point deep socket
    • 6 in extension
  3. For EU trailer sockets only: drill a 6 mm drain hole at the lowest point of the trailer socket, at the hinge side of the socket.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage to the wires and pins inside the socket, carefully drill only through the plastic housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    This drill hole is required to prevent corrosion in the event of water ingress.
  4. Connect the trailer hitch assembly electrical connector.
  5. Install the rear fascia. See Fascia - Rear (Remove and Install).