24/10/2022 08:14:08

Carrier - Rocker Panel - LH (Structural Pack) (Remove and Replace)

Correction code 12202412 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the clips (x2) that attach the LH rocker panel cover to the front and rear wheel arch liners.
    Figure 1. Front shown; rear similar
  2. Release the clips (x11) and tabs (x11) that attach the LH rocker panel cover to the LH rocket panel carrier.
    Tip: Work a plastic trim tool between the door panel and rocker cover to release the tabs.
  3. Remove the bolts (x3) and clips (x4) that attach the LH rocker panel carrier to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Release the clips (x10) that attach the LH rocker panel carrier to the vehicle, and then remove the carrier from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use a pry tool to release the clips and prevent damage to the carrier. Negotiate the carrier around the rear wheel liner, then the front wheel liner.

Install

  1. Maneuver the LH rocker panel carrier around the front wheel arch liner, then the rear wheel arch liner to position it into the vehicle, and then secure the clips (x10) that attach the carrier to the vehicle.
  2. Install the bolts (x3) and clips (x4) that attach the LH rocker panel carrier to the vehicle.
    12 Nm (8.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. With assistance, position the LH rocker panel cover onto the LH rocker panel carrier, and then secure the clips (x11) and tabs (x11) that attach the cover to the carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    The tabs go into the cavities on the rocker carrier and cannot be accessed from the outer side of the cover.
  4. Install the clips that attach the LH rocker panel cover to the front and rear wheel arch liners.
    Figure 2. Front shown; rear similar