19/02/2021 13:35:05

Actuator - Recliner - 3rd Row Seat - LH (Remove and Replace)

Correction code 13032802 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 3rd seat backs. See Seat Backs - 3rd Row (Remove and Replace).
  2. Remove the outer clip that attaches the 3rd row LH inner B-cover to the seat frame assembly.
  3. Release the 3rd row LH recliner actuator cable from the seat frame assembly.
  4. Release the 3rd row LH recliner actuator cable from the clip on seat frame assembly.
  5. Disconnect the 3rd row LH recliner actuator electrical connector.
  6. Remove the bolts that attach the LH 3rd row recliner actuator to the seat frame assembly, and then remove the actuator from the assembly.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Hex bit set with Tamper-proof torx

Install

  1. Position the LH 3rd row recliner actuator onto the seat frame assembly, and then install the bolts that attach the actuator to the assembly.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Hex bit set with Tamper-proof torx
  2. Connect the 3rd row LH recliner actuator electrical connector.
  3. Install the 3rd row LH recliner actuator cable into the clip on the seat frame assembly.
  4. Install the 3rd row LH recliner actuator cable into holding mount on the seat frame assembly.
  5. Install the outer clip that attaches the 3rd row LH inner B-cover to the seat frame assembly.
  6. Install the 3rd seat backs. See Seat Backs - 3rd Row (Remove and Replace).