04/05/2020 14:54:52

Switch - Light - Center Console (Remove and Replace)

Correction code 15190602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all doors and fully lower all windows.
  2. Remove the center console lower rear panel. See Panel - Lower Rear - Center Console (Remove and Replace).
  3. Remove the center console rear vent assembly. See Assembly - Rear Vent - Center Console (Remove and Replace).
  4. Remove the center console end panel. See End Panel - Center Console (Remove and Replace).
  5. Disconnect the electrical connector from the rear of the center console.
  6. Remove the screw that attaches the center console light switch to the center console, and then remove the switch.
    0.5 Nm (4 lbs-in)
    Tip: Use of the following tool(s) is recommended:
    • Torx T15 socket
    • Flex head ratchet/flex head torque wrench

Install

Installation procedure is the reverse of removal.