18/06/2020 08:55:23

Harness - Fascia - Rear (Remove and Replace)

Correction code 17101102 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Release the connector locks (x2), and then disconnect the rear fascia harness connectors (x6).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not push down on the red locking tab. Pull the red tab to release the connector lock.
  3. Remove the clips that attach the rear fascia harness to the upper rear fascia, and then remove the harness from the assembly.

Install

Installation procedure is the reverse of removal.