Brace - Dash Pencil (Remove and Replace
Correction code 10101212 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- Remove the HEPA filter. See Assembly - Filter - HEPA (Remove and Install).
- Remove the fresh air intake duct. See Duct - Fresh Intake (Remove and Replace).
- Remove the RH footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
-
Remove the nut that attaches the car computer to the dashboard (torque 15
Nm).
-
Remove the bolt that attaches the pencil brace to the chassis (torque 10
Nm).
Figure 1. Model Y Non-Structural Pack Figure 2. Model Y Structural Pack -
Remove the dash pencil brace from the vehicle.
Figure 3. Model Y Non-Structural Pack Figure 4. Model Y Structural Pack
Install
Installation procedure is the reverse of removal.