Thermistor - Airwave Duct - LH (Remove and Replace)
Correction code 18104112 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the driver knee airbag assembly. See Airbag - Knee - Driver (Remove and Install).
- Remove the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
-
Disconnect the LH airwave duct
thermistor connector.
-
Release the tabs (x2) that attach the
LH airwave duct thermistor to the airwave duct, and then remove the thermistor from the
duct.
Install
-
Install the LH airwave duct thermistor
into the airwave duct.
NoteMake sure the thermistor is fully seated.
-
Connect the LH airwave duct thermistor connector.
- Install the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
- Install the driver knee airbag assembly. See Airbag - Knee - Driver (Remove and Install).