01/08/2024 00:22:03

IP Carrier (Remove and Replace)

Correction code 14052102 1.98 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-03-29: Revised procedure.
  • 2024-01-29: Re-structured the procedure.
  • 2024-07-30: Added information about how to handle the replacement between different versions of IP carrier.
Table 1. Torque Specifications: IP Carrier (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the LH and RH window defroster ducts to the instrument panel carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 socket
  • 2 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the instrument panel carrier. See IP Carrier (Remove and Install).
  2. Remove the front passenger air bag. See Airbag - Front Passenger (Remove and Install).
  3. Remove the bolts (x2) that attach the LH and RH window defroster ducts to the instrument panel carrier, and remove the ducts.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 2 in extension
    • Ratchet/torque wrench
  4. Remove the LH and RH defrost covers. See Defrost Cover - Instrument Panel - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    4 tabs for the LH side and 5 tabs for the RH side.

Install

  1. If the new instrument panel carrier does not have tweeter holes, the tweeter connectors must be taped back to the harness before the replacement instrument panel carrier is installed.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do NOT cut holes into the new instrument panel carrier as an attempt to retrofit the tweeters.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Failure to tape back the existing tweeter connector may result in NVH issues.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use black tape. The yellow tape used in the picture is for demonstration purpose only.
  2. If the new instrument panel carrier has tweeter holes while the replaced one does not, the tweeter hole must be covered before the replacement instrument panel carrier is installed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cut a piece of butyl to cover the hole. Make sure the butyl does not cover the IP clips or interfere with the speaker perimeter.
  3. Install the LH and RH defrost covers. See Defrost Cover - Instrument Panel - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    4 tabs for the LH side and 5 tabs for the RH side.
  4. Install the bolts (x2) that attach the LH and RH window defroster ducts to the instrument panel carrier.
    2.3 Nm (1.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 2 in extension
    • Ratchet/torque wrench
  5. Install the front passenger air bag. See Airbag - Front Passenger (Remove and Install).
  6. Install the instrument panel carrier. See IP Carrier (Remove and Install).