Headlights - Adjust - NA (Wall Method)
Correction code 17400100 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-04-01: Updated measurements and units.
Identify Headlight Type
Adjust Headlights Using a Wall
-
Position the vehicle for
adjusting the headlights. The vehicle should be:
- Located in a darkened area.
- Parked on a level surface.
- Perpendicular to a wall that has a white matte surface. The wall must be at least 6 ft (1.83 m) high and 12 ft (3.76 m) wide.
- Make sure that all 4 tires are inflated to specification.
- Put a piece of tape on the wall 32 in (81.2 cm) from the ground to indicate where the beam should show.
- Measure 25 ft (7.62 m) away from the wall and put a piece of tape on the ground to indicate where the vehicle should be parked.
- Park the vehicle perpendicular to the wall so that the front fascia is flush with the tape that was placed on the ground in the previous step.
- On the vehicle touchscreen, touch Controls > Service > Adjust Headlamps to enable Headlight Adjustment Mode.
- Cover the RH headlight; make sure that all light from the right headlight is blocked.
-
On the vehicle touchscreen,
select Left, then use the left scroll wheel on the steering wheel
to adjust the beam level.
NoteThe top right part of the beam should align with the tape mark on the wallCAUTIONDo not sit in the vehicle, as this will affect headlight alignment.
- Remove the cover from the RH headlight.
- Repeat step 7 through step 9 covering the LH headlight and adjusting the RH headlight.
- Exit the headlight adjustment mode on the center display.