Sensor - Ambient Air Temperature (Remove and Replace)
Correction code
18107212
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
-
Use a small flat bladed tool
to carefully release the ambient temperature sensor cover from the active
grille shutter.
-
Disconnect the ambient
temperature sensor electrical connector.
-
Release the clip that
attaches the ambient temperature sensor to the active grille shutter.
- Remove the ambient temperature sensor from the vehicle.
Install
-
Install the clip that
attaches the ambient temperature sensor to the active grille shutter.
-
Connect the ambient
temperature sensor electrical connector.
-
Install the ambient
temperature sensor cover to the active grille shutter.
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).