2020-04-16
Harness - Fascia - Front (Remove and Replace)
Correction code
17101002
0.84
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the front fascia. See Fascia - Front (Remove and Install).
-
Disconnect the front fascia harness electrical connectors (x8).
CAUTIONDo not push down on the red tabs. Pull a red tab to disengage the lock, and then release the connector.
-
Use a clip prytool to release the clips (x10) that attach the front fascia harness to the front fascia.
NoteReplace any broken clips.
- Release the 12V hood release terminals from the tow cover by squeezing the retaining tabs together and carefully sliding the terminals off.
- Remove the front fascia harness from the front fascia.
Install
-
Install the clips (x10) that attach the front fascia harness to the front fascia.
NoteMake sure that the harness is routed correctly.
-
Connect the front fascia harness electrical connectors (x8).
CAUTIONMake sure the red tabs are pushed in fully and locked in place.
- Install the 12V hood release terminals onto the tow cover by squeezing the retaining tabs together and carefully sliding the terminals over the retainining tab.
- Install the front fascia. See Fascia - Front (Remove and Install).