Wade Seal - HV Battery (Structural Pack) (Rework)
16103207 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
- 1080593-00-A Caulk and Adhesive Gun
- 1089956-00-A ADHESIVE,CURE IN PLACE,SILICONE,455g
Procedure
-
Prepare the silicone liquid gasket.
NoteThe opening must be 3 mm wide.
-
Clean the affected section of the battery wade seal using IPA wipes.
NoteAllow 1 minute to dry.
-
Apply the silicone liquid gasket to the affected section of the battery
wade seal.
NoteUse the lowest speed setting on the caulking gun.
-
Spread the silicone liquid gasket using IPA and smooth it out with the rest
of the wade seal.
- Let the silicone liquid gasket dry for 20 minutes.