2020-03-06

Speaker - Front Door - LH (Remove and Replace)

Correction code 21210102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Speaker - Front Door - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the front door speaker to the door
4 Nm (2.9 lbs-ft)
  • 8 mm socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 2 in extension
Reuse

Remove

  1. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  2. Disconnect the electrical connector from the front door speaker.
  3. Remove the screws that attach the front door speaker to the door, and then remove the speaker.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 2 in extension

Install

Installation procedure is the reverse of removal.