2020-05-27
Seal - Inner Belt - Rear Door - LH (Remove and Replace)
Correction code
11704102
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
-
Release the clips that
attach the rear and front of
the inner belt seal to the rear door, and then pull up to release
the inner belt seal.
NoteRemove the clips that remain in the door, and then install the clips into the rear and front of the inner belt seal.
Install
- Press the rear door inner belt seal downwards into the rear door.
- Install the clips that attach the inner belt seal to the rear door.
- Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).