2020-05-27
Switch - Closure - Liftgate (Remove and Replace)
Correction code
11352802
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screws that attach the liftgate switch to the liftgate |
![]() 0.5 Nm (4 lbs-in) |
|
Reuse |
Remove
- Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Disconnect the electrical connector from the liftgate switch.
-
Remove the screws that attach the liftgate switch to the liftgate.
NoteUse of the following tool(s) is recommended:
- Torx T20 socket
Install
- Place the liftgate switch in place and make sure that it is oriented correctly.
-
Install the screws that attach the liftgate switch to the liftgate.0.5 Nm (4 lbs-in)NoteUse of the following tool(s) is recommended:
- Torx T20 socket
- Connect the electrical connector to the liftgate switch.
- Install the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
- Close the liftgate.