15/09/2022 14:47:35

Wheel Arch Liner - Front - LH (Structural Pack) (Remove and Replace)

Correction code 12010912 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Raise the vehicle to a comfortable working height.
  4. Remove the rocker bolt and aero shield bolts (x2) that attach the LH front wheel arch liner to the HV battery.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Lower the vehicle partially.
  6. Remove the LH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  7. Remove the push clips (x10 and metal clips (x5) that attach the LH front wheel arch liner to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Metal clips are located behind the rotor.
    Tip: Use a prytool to get cutters under the metal clip.
  8. Release the LH front wheel arch liner from the studs (x5), and then remove the liner from the vehicle.

Install

  1. Position the LH front wheel arch liner into the vehicle and onto the studs (x5), and then tuck the liner behind the front aero shield.
  2. Install the push clips (x10) and metal clips (x5) that attach the LH front wheel arch liner to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a socket to press the metal clip into the liner evenly.
  3. Install the LH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  4. Apply Loctite 222 to the aero shield bolts (x2), and then install the aero shield bolts (x2) and rocker bolt that attach the LH front wheel arch liner to the HV battery.
    12 Nm (8.8 lbs-ft)
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Torque the rocker bolt to 12 Nm and the aero shield bolts (x2) to 6 Nm.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Remove the vehicle from the lift.