2023-02-23

Trim - C-Pillar - Lower - LH (7 Seat) (Remove and Replace)

Correction code 15180522 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH doors and lower all the windows.
  2. Move the driver seat fully forward.
  3. Slide and tilt the LH 2nd row seat fully forward.
  4. Partially remove the lower portion of the LH rear door seal.
  5. Release the clips (x8) that attach the LH lower C-pillar trim to the vehicle, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The rear edge is mated with a groove in the trunk side trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the clips at the front of the LH rear sill trim, and then work towards the rear of sill trim.

Install

  1. Position the LH lower C-pillar trim to the vehicle, and then install the clips (x8) that attach the trim to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The rear edge is mated with a groove in the trunk side trim.
  2. Reseat the LH rear door seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Seat the pillar and sill trim tabs underneath the seal.
  3. Move the LH 2nd row seat to the original position.
  4. Move the driver seat to the original position.
  5. Raise all the windows and close the LH doors.