2026-05-28

Door and Hinge Cover - Charge Port (Remove and Replace)

Correction code 44011702 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-05-27: Removed the charge port voltage check step and updated the hinge cover removal method.
  • 2024-08-08: Removed unnecessary step. Enabled procedure for Model Y.

Remove

  1. Open the charge port door.
  2. Using a small screwdriver to pry at the hinge cover mounting location, slightly twist and slide the hinge cover down.
  3. Remove the screws (x2) that attach the charge port door to the hinge, and then remove the charge port door from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  4. Adjust the position of the charge port door hinge appropriately as needed, and then slide up to remove the hinge cover.

Install

  1. Install the hinge cover by sliding it down from the top of the hinge.
  2. Slide the hinge cover down to access the mounting point for the charge port door.
  3. Lift the locking tab and push the cover further down to uncover the bolt holes.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a hook to hold the hinge if needed. Do not overstress the cover.
  4. Position the charge port door onto the hinge, and then install the screws (x2) that attach the charge port door to the hinge.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  5. Slide the hinge cover up towards the charge port door.
  6. Close the charge port door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not try to manually close the charge port door.