15/06/2022 14:49:56
Raise Vehicle - 2 Post Lift
Correction code 10000205 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Note
A vehicle lifting procedure is available for Mobile Service. See Raise Vehicle - Floor Jack (Mobile Service).
Raise
Warning
To
reduce the risk of personal injury, use appropriate equipment while performing this
operation.
Warning
Do not work on an incorrectly supported vehicle.
Warning
Failure to follow the critical steps and checks of this
procedure can lead to serious injury or death.
CAUTION
This procedure
lifts the vehicle for service operations other than HV battery replacement. When
replacing the HV battery, follow lifting instructions within that
procedure.
-
Disconnect the charging cable from the vehicle.
WarningDo not attach the charging cable to the charge port while the vehicle is on the lift.CAUTIONPerform a visual check of the lift according to the equipment operator's manual before using the lift.
- Move the lifting arms fully outward.
- Position the vehicle centrally between the lift posts, and that the steering wheel is in line with the lift posts.
-
Position the front and rear lifting arm pads under the vehicle lift points on the HV battery as shown.
WarningThis procedure lifts the vehicle for service operations other than HV battery replacement. When replacing the HV battery, follow lifting instructions within that procedure.
- Adjust the lifting arm pads to the optimum height.
- Make sure that the hood, liftgate, and all doors are closed, unless necessary for the work to be performed.
- Check that the arms are correctly located, and make sure that no part of the vehicle is in danger of contacting the ceiling, tool boxes, or other items in the service area when the vehicle is raised.
-
Raise the vehicle slightly,
and check the following:
- Make sure all 4 pads are in the correct position.
- Check the balance of the vehicle.
- Make sure that the four arms are properly locked and cannot rotate.
CAUTIONIf the procedure requires the hood, liftgate, or doors to be open while the vehicle is raised, closely watch their position as the vehicle is being raised to avoid contact with the lift mechanism, ceiling, or objects hanging from the ceiling. - Raise the vehicle to the necessary service height, and then lower the lift until the safety locks are properly engaged.
Lower
- Make sure that no tools, equipment, other items, or personnel are under the vehicle or under any open doors.
-
Disengage any lift safety locks, and fully lower the vehicle.
CAUTIONTo avoid injuries, stay clear from the vehicle.
- Move the lifting arms fully out from under the vehicle, and lower the lifting pads.
- Close any open hood, liftgate, or doors as necessary.
- Remove the vehicle from the lift.