2024-09-04

Wheel Arch Liner - Rear - LH (Non-Structural Pack) (Remove and Replace)

Correction code 12011102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1133569-00-A Pliers, Clip Removal
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-06-08: Added the whole procedure video as an overview for supplemental purposes only.

Remove

  1. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  2. Release the clips (x16) that attach the LH rear wheel arch liner to the vehicle, and then remove the liner from the vehicle

Install

Installation procedure is the reverse of removal.