05/04/2024 14:40:00

Oil Pump - Front Drive Unit (Remove and Replace)

Correction code 39301602 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-11-09: Added a note to allow at least 10 minutes oil drain time and the underhoist stand tool.
  • 2023-04-14: Added instructions to lower the front drive unit.
  • 1081765-00-A 3/4 TON UNDERHOIST STAND

Remove

  1. Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the front aero shield panel. See Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
  5. Release the locking tab, and then press down on the tab to disconnect the oil pump connector.
  6. Position an oil drain container underneath the front drive unit oil filter and oil pump.
  7. Support the LH side of the front drive unit with an underhoist stand, as shown.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Place a show towel between the underhoist stand and front drive unit.
  8. Remove the bolt that attaches the front drive unit to the front subframe.
    80 Nm (59.0 lbs-ft)
  9. Carefully lower the front underhoist stand until the front drive unit oil pump is accessible.
  10. Remove the bolts that attach the front drive unit oil pump to the front drive unit.
    5 Nm (3.7 lbs-ft) + 20 degrees
  11. Remove the bolts that attach the front drive unit oil pump to the front drive unit.
    Tip: Use of the following tool(s) is recommended:
    • 4 in extension
    • EPL 10 socket
    • ¼ in to 3/8 in adapter
  12. Carefully pry the oil pump away from the front drive unit to remove it, and then allow the oil to drain.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow at least 10 minutes for the gearbox fluid to drain from the front drive unit, or until a slow drip exits the front drive unit.
  13. Remove the oil filter from the front drive unit.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tesla recommends that the oil filter is replaced with a new one upon removal. Any oil filter with visible corrosion or leaks must be replaced.
  14. Remove the fill plug from the front drive unit.
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 8 mm hex