Hose - Supply - Powertrain (Non-Structural Pack) (Remove and Replace)
Correction code 18303302 3.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the HV battery. See HV Battery (AWD) (Non-Structural Pack) (Remove and Install).
-
Release the clip and disconnect the powertrain supply hose fitting from the RH underside of the ancillary bay.
-
Release the clips (x5) that attach the powertrain supply (upper) hose to the RH side of the HV battery, and remove the hose from the HV battery.
- Remove the plug from the powertrain supply hose, if installed.
Install
Installation procedure is the reverse of removal.