Seal - Outer Belt - Front Door - LH (Remove and Replace)
Correction code
11703002
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Open the LH front door and lower the LH front window fully.
-
Pull up and then pry to release the LH front door outer belt seal from the door using a plastic trim tool, and then remove the seal from the door.
Install
-
Install the LH front door outer belt seal onto the door assembly by pushing down to secure it.
NoteUse P-80 emulsion lubricant to ease installation of the seal.
- Close the LH front door and raise the LH front window.