13/05/2021 16:48:15

Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)

Correction code 13011812 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all the doors and fully lower all the windows.
  2. Move the driver seat fully forward.
  3. Remove and discard the bolts (x2) that attach the rear of the driver seat to the body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use only the Torx Plus T45 bit to remove the seat bolts.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx Plus T45 socket
    • 3/8 in std flex head ratchet
    • 3/8 in flex head torque wrench (installation only)
  4. Move the driver seat fully rearward.
  5. Remove and discard the bolts (x2) that attach the front of the driver seat to the body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use only the Torx Plus T45 bit to remove the seat bolts.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx Plus T45 socket
    • 3/8 in std flex head ratchet
    • 3/8 in flex head torque wrench (installation only)
  6. Lift the driver seat upward, and then slide the track covers forward to remove from the seat assembly.

Install

  1. Install the seat track covers into the vehicle.
  2. Move the driver seat fully rearward.
  3. Install new bolts (x2) to attach the front of the driver seat to the body.
    33.5 Nm (24.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use only the Torx Plus T45 bit to torque the seat bolts.
  4. Move the driver seat fully forward.
  5. Install new bolts (x2) to attach the rear of the driver seat to the body.
    33.5 Nm (24.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use only the Torx Plus T45 bit to torque the seat bolts.
  6. Move the driver seat to its original position.
  7. Raise all the windows and close all the doors.