05/03/2020 13:38:36
Thermistor - Duct - Lower - LH (Remove and Replace)
Correction code
18104102
0.30
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the LH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).
- Disconnect the LH lower duct thermistor electrical connector.
- Release the clips that attach the LH lower duct thermistor to the HVAC assembly, and then pull the LH lower duct thermistor straight out from the HVAC assembly.
Install
- Push the LH lower duct thermistor into the HVAC assembly until the retaining clips are fully secure.
- Connect the LH lower duct thermistor electrical connector.
- Install the LH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).