2022-08-24

Antenna - Ground Noise Filter - LH (Remove and Replace)

Correction code 21300012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  2. Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
  3. Disconnect the LH ground noise filter antenna from the backlite glass.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage glass.
  4. Remove the bolt and release the clip that attach the LH ground noise filter antenna to the vehicle, and then remove the antenna from the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx Plus IP30 socket
    • 4 in extension

Install

Installation procedure is the reverse of removal.