Cup Holder - 2nd Row (Remove and Replace)
Correction code
13082002
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Open the LH rear door and fully lower the window.
-
Fold down the armrest.
-
Use a plastic trim tool to release the cup holder from the locking tabs.
-
Lift up on the cup holder and remove it from the vehicle.
Install
-
Install a new cup holder into the armrest.
NotePress firmly on the edges of the cup holder to engage the locking tabs.
-
Return the armrest to the upright position.
- Close the LH rear door and raise the window.