2020-04-16
Lumbar Bun - 2nd Row - Center/20 (Remove and Replace)
Correction code
13059502
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screw that attaches the 2nd row center/20 lumbar bun to the 2nd row seat |
![]() 1.5 Nm (1.1 lbs-ft) |
|
Reuse |
Remove
- Remove the 2nd row center/20 seat back panel. See Remove.
-
Remove the screw that attaches the 2nd row center/20 lumbar bun to the 2nd row seat.
NoteUse of the following tool(s) is recommended:
- Torx T20 socket
- Raise the center/20 seat back into the upright position.
-
Release the clips (x2) that attach the seat bun to the seat assembly, and then remove the seat bun from the vehicle.
NotePull the bolsters outwards simulatenously to aid removal.
Install
- Install the seat bun into the seat assembly, making sure the clips are fully secure.
- Fold the center/20 seat down.
-
Install the screw that attaches the 2nd row center/20 lumbar bun to the 2nd row seat.1.5 Nm (1.1 lbs-ft)NoteUse of the following tool(s) is recommended:
- Torx T20 socket
- Install the 2nd row center/20 seat back panel. See Install.