2023-04-13

Thermistor - Duct - Upper - LH (Remove and Replace)

Correction code 18101102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).
  2. Disconnect the LH upper duct thermistor electrical connector.
  3. Release the clips that attach the LH upper duct thermistor to the HVAC assembly, and then route the LH upper duct thermistor through the access hole in the trim to remove it from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use a 90 degree, 6 in pick to release the tabs.

Install

  1. Route the LH upper duct thermistor through the access hole in the trim, and then push the LH upper duct thermistor into the HVAC assembly until the retaining clips are fully secure.
  2. Connect the LH upper duct thermistor electrical connector.
  3. Install the LH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace).