Cushion - Seat - 3rd Row (Remove and Replace)
Correction code
13060032
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Open all the doors and fully lower all the windows.
- Move the LH front seat fully forward.
- Position the LH 2nd row seat into easy entry mode.
- Move the RH front seat fully forward.
- Position the RH 2nd row seat into easy entry mode.
-
Pull the LH and RH release levers under the 3rd row seat cushion to release
the cushion from the seat assembly.
NoteDo not pull the seat cushion away from the seat assembly as there is still an electrical connector connected.
-
Disconnect the harness
electrical connector.
-
Remove the 3rd seat cushion from the vehicle.
Install
-
Position the 3rd row seat cushion into the vehicle, and then connect the
harness electrical connector.
- Push down on the 3rd seat cushion to engage the latches.
- Move the front seat and 2nd row seats to the original positions.
- Raise all the windows and close all the doors.