Plastic Insulator - Suspension - Driver Seat (Remove and Replace)
Correction code
13010032
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the driver seat from the vehicle. See Seat Assembly - 1st Row - LH (Remove and Replace).
-
Remove the driver seat
backrest lumbar support. See:
- For driver seat: Lumbar Support - Backrest - Driver Seat (Remove and Replace).
- For front passenger seat: Lumbar Support - Back Rest - Front Passenger Seat (Remove and Replace).
-
Remove the driver seat suspension plastic insulator.
Install
-
Install the driver seat suspension plastic insulator.
-
Install the driver seat
backrest lumbar support. See:
- For driver seat: Lumbar Support - Backrest - Driver Seat (Remove and Replace).
- For front passenger seat: Lumbar Support - Back Rest - Front Passenger Seat (Remove and Replace).
- Install the driver seat into the vehicle. See Seat Assembly - 1st Row - LH (Remove and Replace).