USB Hub - Center Console - Front (Remove and Replace)
Correction code
21260402
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screws that attach the USB hub to the center console |
![]() 1.1 Nm (.8 lbs-ft) |
|
Reuse |
Remove
- Disconnect the LV battery power. See 12V/LV Power (Disconnect and Connect).
- Open the sliding bin lid of the center console.
- Release the clips (x2) through the slots with a pick, and then release the rest of the clips (x3) that attach the bottom of the USB hub to the center console.
- Disconnect the electrical harness from the USB hub connectors (x2), and then remove the USB hub from the center console.
-
Remove the screws (x3) that
attach the USB hub to the USB panel, and then remove the hub from the
panel.1.1 Nm (.8 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 socket
Install
Installation procedure is the reverse of removal.