2025-03-04

Connector - Pedestrian Warning Speaker (CN) (Remove and Replace)

Correction code 171007520.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the RH front wheel. See Wheel Assembly (Remove and Install).
  2. Remove the RH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  3. Remove the clips (x8) that attach the front portion of the RH front wheel arch liners to the vehicle, and then move the wheel arch liner aside to perform the following steps.
  4. Release the clip that attaches the electrical harness to the pedestrian warning speaker assembly.
  5. Disconnect the pedestrian warning speaker connector.
  6. Remove the connector locking cover, and then press down on the pins (x2) while pulling the harness downwards to remove the connector from the vehicle.

Install

  1. Insert the pins (x2) into the connector, and then install the connector locking cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a pull-push-pull test to verify the pins are fully seated.
  2. Connect the pedestrian warning speaker connector.
  3. Install the clip that attaches the electrical harness to the pedestrian warning speaker assembly.
  4. Install the clips (x8) that attach the front portion of the RH front wheel arch liners to the vehicle.
  5. Install the RH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  6. Install the RH front wheel. See Wheel Assembly (Remove and Install).