16/06/2023 08:53:35

Seal - Secondary - Front Door - LH (Remove and Replace)

Correction code 11705002 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Release the LH front door inner belt seal and glass run seal clips (x3) to fully access the secondary seal.
  3. Use narrow-width tape to carefully mark the location of the secondary seal around the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure that the edge of the tape accurately follows the edge of the seal.
  4. Release the ends of the door secondary seal from the rear of the inner belt seal and the door glass run seal.
  5. Slowly peel the length of the secondary seal from the perimeter of the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Discard the seal as it can not be reused.
  6. Clean any remaining adhesive or residue from the door.

Install

  1. Ensure the area where the secondary seal will be installed is clean.
  2. Peel a short section of the seal backing on each end of the seal and position the ends into the door assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the open edge of the seal is facing the inside of the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the front edge of the seal is under the cutout for the glass run seal, and the rear edge is under the cutout for the inner belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the drain holes of the seal are at the bottom of the door.
    Figure 1. Face open edge inward
    Figure 2. Quarter glass run seal cutout
    Figure 3. Inner belt seal cutout
  3. Firmly press the remaining portion of the seal into place while removing the film from the double sided tape.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not stretch the seal as it is applied to the door.
  4. Remove the marking tape from the door.
  5. Install the LH front door inner belt seal and glass run seal clips (x3).