05/03/2021 10:07:02
NVH Insulator - 3rd Row Seat (Remove and Replace)
Correction code
13060052
0.60
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the 3rd row carpet. See Carpet - 3rd Row (Remove and Replace).
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
-
Disconnect the HVC logic electrical connector, and then install the logic
cap.
-
Remove the 3rd row NVH insulator.
Install
-
Install the 3rd row NVH insulator.
-
Remove the logic cap, and then connect the HVC logic electrical
connector.
NoteAlign the connector, and then pull the handle to the locking position to fully seat the connector.
- Connect 12V power. See 12V/LV Power (Disconnect and Connect).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Install the 3rd row carpet. See Carpet - 3rd Row (Remove and Replace).