24/10/2022 09:22:37

Casting - Podium - 2nd Row Seat - LH (7-Seat) (Remove and Replace)

Correction code 13020132 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat assembly from the vehicle. See Seat Assembly - 2nd Row - LH (7-Seat) (Remove and Replace).
  2. Remove the push clip from the front of the LH 2nd row seat outer sideshield assembly.
    Tip: Use a pick to remove the push clip from the bottom side of the outboard cover.
  3. Release the clip that attaches the LH 2nd row seat outer sideshield to the seat assembly, disconnect the electrical connector, and then remove the sideshield from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the outer sideshield assembly by pulling outwards and up at the front portion of the trim, and then releasing the remaining clip.
  4. Release the clips (x3) that attach the LH 2nd row seat inboard outer trim to the seat assembly, and then remove the trim from the seat assembly.
  5. Remove the seat pan fastener from the LH front of the LH 2nd row seat.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    1x fastener,10mm, 6Nm
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Release the clips (x2) that attach the front of the LH 2nd row seat cushion to the seat assembly, and then lift the front edge of the seat cushion to access the podium fasteners.
  7. Remove and discard the bolts (x2) and release the harness clip that attach the LH 2nd row seat podium casting to the seat assembly, and then remove the casting from the seat assembly.
    37 Nm (27.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm socket

Install

  1. Position the LH 2nd row seat podium casting into the seat assembly, and then secure the harness clip and install new bolts (x2) that attach the casting to the seat assembly.
    37 Nm (27.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm socket
  2. Position the front edge of the LH 2nd row seat cushion onto the seat assembly, and then install the clips that attach the cushion to the seat assembly.
  3. Install the seat pan fastener to the LH front of the LH 2nd row seat.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    1x fastener,10mm, 6Nm
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Position the LH 2nd row seat outer sideshield to the seat assembly, connect the electrical connector, and then secure the clip that attaches the sideshield to the seat assembly.
  5. Install the push clip at the front of the LH 2nd row seat outer sideshield assembly.
  6. Position the LH 2nd row seat inboard outer trim onto the seat assembly, and then secure the clips (x3) that attach the trim to the seat assembly.
  7. Install the LH 2nd row seat assembly. See Seat Assembly - 2nd Row - LH (7-Seat) (Remove and Replace).