Striker - Hood (Remove and Replace)
Correction code
11352902
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts that attach the striker to the hood |
![]() 18 Nm (13.3 lbs-ft) |
|
Reuse | Do not torque until vehicle is within gap and flush specification |
Remove
- Open the hood.
- Use masking tape to mark the location of the hood striker on the hood assembly.
-
Use a T40 socket to remove the bolts that attach the hood striker to the hood, and then remove the striker from the hood.
Install
-
Install the striker on to the hood, but do not fully torque the bolts.
NoteUse the masking tape and hood indentations as a guide.
- Close the hood and use the gap and flush tool to verify alignment is within specification.
- Open the hood and adjust the striker position as necessary.
- Repeat step 2 and step 3 until alignment is satisfactory.
-
Fully tighten the bolts.18 Nm (13.3 lbs-ft)
- Remove the masking tape, and then close the hood.