27/02/2023 15:20:27

Tweeter Assembly - Front Door - LH (with Tether) (Remove and Replace)

Correction code 21212732 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Carefully release the clips (x2) and body hook that attach the LH front door tweeter assembly to the door trim panel and body, disconnect the connector, and then hang the assembly aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the tweeter assembly upwards to release the clips.
    Informational PurposesAn informational icon, calling your attention
    Note
    The tether will still be connected.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tethered units can be used to replaced non-tethered tweeters. However, if the vehicle is equipped with a tethered tweeter, then it must be replaced with a tethered unit in all instances.
  3. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  4. Take note of the tether routing, and then unhook the tether to remove the LH front door tweeter assembly from the door assembly.

Install

  1. Position the LH front door tweeter onto the door assembly, feed the strap in, secure it over the body hook, and then hang the tweeter assembly aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the tether stays in the position circled in red.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the tether using the routing noted during removal.
    Tip: Use a trim to aid in installation if needed.
  2. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  3. Position the LH front door tweeter assembly onto the door panel, connect the connector, and then secure the clips (x2) and hook that attach the assembly to the door panel and body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the component is fully engaged and the tether is not exposed from under the trim.
  4. Raise the LH front window and close the LH front door.