18/12/2023 11:10:54

Additional Key - Program (Existing Key Present)

Correction code – Key Fob: 17450503Key Card: 17450406 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Note
Perform this procedure if an authenticated key is available. If no authenticated key is available, see Replacement Keys - Program (No Keys Present).
Informational PurposesAn informational icon, calling your attention
Note
The vehicle supports up to 19 keys. When reaching this limit, a key must be deleted before a new key can be added.

Adding an Additional Key Card or Key Fob

Informational PurposesAn informational icon, calling your attention
Note
If adding a key fob, make sure the key fob is at room temperature. Pairing may be unsuccessful if the key fob is cold.
  1. On the touchscreen, touch Controls > Locks, and then touch + in the "Keys" section.
  2. Scan the new key card or key fob on the key reader behind the cup holders on the top of the center console. After the new key card or key fob is recognized, remove it from the key reader.
  3. Scan an already-authenticated (i.e. already has access to the vehicle) key card or key fob on the key reader behind the cup holders on the top of the center console.
  4. When complete, the key list on the touchscreen displays the newly authenticated key.
    Informational PurposesAn informational icon, calling your attention
    Note
    You can customize the name of the key by touching the associated pencil icon.
  5. Tap the new key against the driver's side B-pillar applique to verify that the key locks and unlocks the vehicle.
  6. Place the new key onto the key reader behind the cup holders on top of the center console to verify it is authenticated and can start the vehicle.

Adding a Phone Key

Informational PurposesAn informational icon, calling your attention
Note
To add a new phone key, Bluetooth must be enabled and the phone must have the Tesla mobile app installed and connected to the vehicle’s Tesla account.
  1. While sitting in the vehicle, open the Tesla mobile app and select the appropriate vehicle (if there are multiple vehicles associated with the account), and then touch Phone Key > Start.
  2. Scan an already-authenticated key card or key fob on the key reader behind the cup holders on the top of the center console.
  3. When the mobile app indicates that the pairing was successful, touch Done. The key list on the touchscreen (Controls > Locks) displays the new phone key. The name of the phone key is determined by the name used in the phone’s settings.