23/07/2024 17:23:26

2nd Row Seat Back Hardware - 2R Seat Center Top Tether Cap (Remove and Install)

Correction code 1305003041 1305003042 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-04-02: Cleaned up topic.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Open the 2nd row seat center top tether cap, and then lift the cap upwards to release the tabs (x2) that attach the cap to the body.

Install

  1. Install the 2nd row seat center top tether cap.
    Informational PurposesAn informational icon, calling your attention
    Note
    x2 tabs
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the cap downwards to secure it, and then close the cap.
  2. Raise the LH rear window and close the LH rear door.