05/08/2024 03:30:01
NVH Tape - Brake Pads - Rear (EMEA) (Retrofit)
Correction code 33010806 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-08-05: Updated instructions to apply tape only on inner brake pads.
- 2024-07-15: Updated procedure for pre-cut stickers and added region information.
- 2024-06-25: Updated notes.
- 1994754-00-A STICKER FOR CALIPER
- 1021050-00-A PRIMER, TAPE, 3M, No. 94
Procedure
Note
This is an additional
procedure, to prevent NVH issues. This procedure is for the EMEA market. Add
this correction code as an extra procedure to the service activity.
Note
This additional procedure can be performed when the rear brake pads are
replaced.
Note
This procedure is only for the inner rear brake pads on the piston side of the
caliper. It is not necessary to apply tape to the outer brake pads that are
mounted directly to the caliper.
- Clean the back side of the inner rear brake pads (x2) and the surfaces of the brake caliper pistons (x2) using brake cleaner.
- Apply primer to the back side of the inner rear brake pads (x2), and then allow 5 minutes to dry.
- Cut the NVH stickers (x2) at the indicated line, to create 80 mm long stickers for the inner rear brake pads.
- Align the NVH stickers to the back side of the inner rear brake pads (x2), and then apply pressure on the pieces of NVH tape to adhere them to the brake pads.
- Remove the protective cover from the NVH stickers applied to the brake pads (x2), and then cut away the NVH stickers at the location of the holes (x2) of each brake pad.
- Proceed with the installation of the rear brake pads.